User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 6 Broadband
LTE Series User’s Guide
66
Figure 38 Network Setting > Broadband
The following table describes the labels in this screen.
6.3 Cellular WAN
Click Network Setting > Broadband > Cellular WAN to display the following screen. Use this screen to
enable data roaming and network monitoring when the Zyxel Device cannot ping a base station.
Note: Roaming charges may apply when Data Roaming is enabled.
Table 13 Network Setting > Broadband
LABEL DESCRIPTION
# This is the index number of the entry.
Name This is the service name of the connection.
Type This shows whether it is a cellular or Ethernet connection.
Mode This shows the connection is in routing mode.
Encapsulation This is the method of encapsulation used by this connection.
802.1p This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
802.1q This indicates the VLAN ID number assigned to traffic sent through this connection. This displays
N/A when there is no VLAN ID number assigned.
IGMP Proxy This shows whether the Zyxel Device act as an IGMP proxy on this connection.
NAT This shows whether NAT is activated or not for this connection.
Default
Gateway
This shows whether the Zyxel Device use the WAN interface of this connection as the system
default gateway.
IPv6 This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
MLD Proxy This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection. MLD
is not available when the connection uses the bridging service.
Modify Click the Edit or Modify icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.