User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 6 Broadband
LTE Series User’s Guide
67
Figure 39 Network Setting > Broadband > Cellular WAN
The following table describes the fields in this screen.
6.4 Cellular APN
Click Network Setting > Broadband > Cellular APN to display the following screen.
Note: APN information can be obtained from the service provider.
Automatic APN Mode is not supported when operating in 3G only mode.
Table 14 Network Setting > Broadband > Cellular WAN
LABEL DESCRIPTION
Antenna
Antenna Select Select between External or Internal Antenna for your Zyxel Device.
Roaming
Data Roaming Click this to enable ( ) data roaming on the Zyxel Device.
4G roaming is to use your mobile device in an area which is not covered by your service provider.
Enable roaming to ensure that your Zyxel Device is kept connected to the Internet when you are
traveling outside the geographical coverage area of the network to which you are registered.
Apply Click this to save your changes.
Cancel Click this to exit this screen without saving.