User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 6 Broadband
LTE Series User’s Guide
71
The following table describes the labels in this screen.
After selecting to disable the following warning appears. Click OK to continue.
Figure 44 Network Setting > Broadband > Cellular PLMN > Manual Scan Warning
Click Scan to check for available PLMNs in the area surrounding theZyxel Device, and then display them
in the network list. Select from the network list and click Apply.
Table 18 Network Setting > Broadband > Cellular PLMN
LABEL DESCRIPTION
PLMN Management
PLMN Auto Selection Click to enable ( ) and have the Zyxel Device automatically connect to the first
available mobile network.
Select disabled to display the network list and manually select a preferred network.
Apply Click Apply to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.