User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 6 Broadband
LTE Series User’s Guide
74
6.9 Cellular Lock
Cellular Lock locks the CPE to the base station that it is currently connected to. This is useful if the CPE is
within range of multiple base stations, and you would prefer the CPE to connect to one base station
over the others.
Click Network Setting > Broadband > Cellular Lock. The following screen displays.
Figure 48 Cellular Lock
The following table describes the fields in this screen.
Passthrough
Mode
Select Dynamic to allow traffic to be forwarded to any LAN computer on the local network of the
Zyxel Device. Select Fixed to allow traffic to be forwarded to a specific LAN computer on the local
network of the Zyxel Device.
Note: This field will show upon enabling IP Passthrough in the previous field.
Passthrough
to fixed MAC
Enter the MAC address of a LAN computer on the local network of the Zyxel Device upon
selecting Fixed in the previous field.
Note: This field will show upon selecting Fixed in the previous field.
Apply Click this to save your changes.
Cancel Click this to exit this screen without saving.
Table 20 Network Setting > Broadband > Cellular IP Passthrough (continued)
LABEL DESCRIPTION
Table 21 Cellular Lock
LABEL DESCRIPTION
PCI Lock Select this to enable or disable PCI (Physical Cell Identifier) Lock.
Add New Rule Select this if you want to add a new rule or to configure cellular lock rules.
Physical Cell ID Use this to enter the PCI number of the base station you choose to connect to
(0~504).
RFCN Use RFCN (Radio Frequency Channel Number) to enter the LTE frequency of the
selected PCI number(1~65535).