User's Manual

113
Enable DHCP relay to have the AAM relay client TCP/IP configuration
requests to a DHCP server and the server’s responses back to the clients.
Enter the IP address of the DHCP server to which the AAM should relay DHCP
client TCP/IP configuration requests.
MSAP2000 AAMS User’s Guide
Figure 52 DHCP Relay
The following table describes the labels in this screen.
Table 40 DHCP Relay
LABEL DESCRIPTION
Enable DHCP
relay
Remote DHCP
server IP
Enable Option 82 Select the Enable Option 82 check box to have the MSAP2000 AAMS add
information (slot number, port number and VLAN ID) to client TCP/IP
configuration requests that it relays to a DHCP server.
Option82 Use this field to specify up to 23 ASCII characters of additional information for
the MSAP2000 AAMS to add to the DHCP client TCP/IP configuration
requests that it relays to a DHCP server.
Examples of information you could add would be the chassis number or the
device identifier of the MSAP2000 AAMS.
Apply Click Apply to save your changes to the MSAP2000 AAMS’s volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.