User's Manual

121
MSAP2000 AAMS User’s Guide
The following table describes the labels in this screen.
Table 47 Access Control: Logins
LABEL DESCRIPTION
Return Click Return to go back to the previous screen.
Administrator
This is the default administrator account with the “admin” user name. You cannot change the
default administrator user name.
Old Password Type the existing system password ("1234" is the default password when shipped).
New Password Enter your new system password.
Retype to confirm Retype your new system password for confirmation.
Apply Click Apply to save your changes to the MSAP2000 AAMS’s volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
18.3.6 Service Access Control Configuration
Click Advanced Application and Access Control from the navigation panel and
then Service Access Control from the Access Control screen to open the
following screen. Use this screen to set which services may be used to access the
MSAP2000 AAMS.
Figure 59 Access Control: Service Access Control
The following table describes the labels in this screen.
Table 48 Access Control: Service Access Control
LABEL DESCRIPTION
Return Click Return to go back to the previous screen.
Services Services you may use to access the MSAP2000 AAMS are listed here.
Active Select the Active check boxes for the corresponding services that you
want to allow to access the MSAP2000 AAMS.
Server Port For Telnet, FTP or web services, you may change the default service port by
typing the new port number in the Server Port field. If you change the default
port number then you will have to let people (who wish to use the service)
know the new port number for that service.