User's Manual

123
MSAP2000 AAMS User’s Guide
C HAPTER 19
Routing Protocol
This chapter shows you how to configure the static routing function.
19.1 Static Route
Static routes tell the MSAP2000 AAMS how to forward the MSAP2000 AAMS’s
own IP traffic when you configure the TCP/IP parameters manually. This is
generally useful for allowing management of the switch from a device with an IP
address on a different subnet from that of the switch’s IP address
(remote management).
Click Routing Protocol in the navigation panel and then Static Routing to
display the screen as shown.
Figure 61 Static Routing
The following table describes the related labels you use to create a static route.
Table 50 Static Routing
LABEL DESCRIPTION
Name Type a name to identify this static route. Use up to 31 ASCII characters. Spaces
and tabs are not allowed.
Destination IP This parameter specifies the IP network address of the final destination. Routing is
Address always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet Mask Enter the subnet mask for this destination