User's Manual

207
MSAP2000 AAMS User’s Guide
Figure 120 VLAN Frame Type Command Example
ras> switch vlan frametype 3 tag
27.8.9 VLAN CPU Show Command
Syntax:
switch vlan cpu show
This command displays the management VLAN (CPU). You can only use
ports that are members of this management VLAN in order to manage the
MSAP2000 AAMS.
27.8.10 VLAN CPU Set Command
Syntax:
switch vlan cpu set <vid>
where
<vid>
= The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already
configured. The VLAN must also have at least one
port set to the fixed status.
This command sets the management VLAN (CPU). You can only manage the
MSAP2000 AAMS through ports that are members of the management VLAN.
Note: By default, you can access the management VLAN from all the Ethernet
and ADSL ports since they are all in the management VLAN). If you need
more security, please see the following example.
27.8.11 Configuring Management VLAN Example
Note: After the following example configuration, you must connect to the first
Ethernet port through a VLAN aware device that is using the proper VLAN
ID in order to perform management.
By default, the MSAP2000 AAMS’s ADSL ports are members of the
management VLAN (VID 1). The following procedure shows you how to
configure a tagged VLAN that limits management access to just one Ethernet
port.
Note: Use the console port to configure the MSAP2000 AAMS if you misconfigure
the management
VLAN and lock yourself out.