User's Manual

209
MSAP2000 AAMS User’s Guide
where
<vlanlist>
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~
10>.
You cannot delete a VLAN if any PVIDs are set to use
the
VLAN or the VLAN is the CPU (management) VLAN.
This command deletes the specified VLAN ID entry from the static VLAN table
The following example deletes entry 2 in the static VLAN table.
Figure 124 VLAN Delete Command Example
ras> switch vlan delete 2
27.9 VLAN Enable
Syntax:
switch vlan <vid>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
27.10 VLAN Disable
Syntax:
switch vlan disable <vid>
This command disables the specified VLAN ID in the SVLAN (Static VLAN)
table. You cannot disable a VLAN if any PVIDs are set to use the VLAN or the
VLAN is the CPU
(management) VLAN.
27.10.1 VLAN Show Command
Syntax
switch vlan show <vlanlist>
where
<vlanlist> = You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~
10>.