User's Manual

214
MSAP2000 AAMS User’s Guide
where
<portlist>
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
This command enables the MAC count filter on the specified ADSL port(s).
You can only enable the MAC count filter on ADSL ports that do not have the
MAC filter enabled.
The following example turns on the MAC count filter on ADSL port 4.
Figure 132 MAC Count Enable Command Example
ras> switch mac count enable 4
27.12.3 MAC Count Disable Command
Syntax:
switch mac count disable <portlist>
where
<portlist>
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
This command disables the MAC filtering feature on the specified ADSL port(s).
The following example turns off the MAC count filter on ADSL port 4.
Figure 133 MAC Count Disable Command Example
ras> switch mac count disable 4
27.12.4 MAC Count Set Command
Syntax:
switch mac count set <portlist> <count>