User's Manual

216
MSAP2000 AAMS User’s Guide
This command displays the packet type filter settings on the specified ADSL port(s)
or on all
ADSL ports if no port is specified.
The following example displays the packet type filter settings for ADSL port 9.
A “V” in a column means that the port is set to allow that type of packets to
pass through.
Figure 135 Packet Filter Show Command Example
ras> switch pktfilter show 9
V: pass through, -: filter out
port pppoe ip arp netbios dhcp eapol igmp
---- ----- -- --- ------- ---- ----- ----
9 V - V - - - V
27.13.2 Packet Filter Set Command
Syntax:
switch pktfilter set <portlist>
[pppoe|ip|arp|netbios|dhcp|eapol|igmp|none]
where
<portlist>
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range
of ports
<1,5,6~10>.
[pppoe|ip|ar
p|netbios|dh
cp|eapol|igm
p|none]
= [pppoe] Reject PPPoE packets. (Point-to-Point Protocol over
Ethernet) relies on PPP and Ethernet. PPPoE is a specification
for connecting the users on an Ethernet to the Internet through
a common broadband medium, such as a single DSL line,
wireless device or cable modem.
[ip]
Reject IP packets. Internet Protocol. The underlying protocol
for routing packets on the Internet and other TCP/IP-based
networks.
[arp] Reject ARP packets. Address Resolution Protocol is a
protocol for mapping an Internet Protocol address (IP address)
to a physical computer address that is recognized in the local
network.
[netbios] Reject NetBIOS packets. (Network Basic Input/Output
System) are TCP or UDP broadcast packets that enable a
computer to connect to and communicate with a LAN.
[dhcp] Reject DHCP packets. Dynamic Host Configuration Protocol
automatically assigns IP addresses to clients when they log on.
DHCP centralizes IP address management on central computers
that run the DHCP server program. DHCP leases addresses, for a
period of time, which means that past addresses are “recycled” and
made available for future reassignment to other systems.