User's Manual

219
Se
t
s the managemen
t
IP address
and subnet mask.
Add a routing table entry.
MSAP2000 AAMS User’s Guide
For example, use the following command sequence sets the MSAP2000 AAMS to
have 192.168.1.3 as the
IP address, 255.255.255.0 for the subnet mask and 192.168.1.233 for the default
gateway.
ras> ip set 192.168.1.3/24 ras> ip
gateway 192.168.1.233 ras> config
save
Figure 137 IP Settings and Default Gateway Address
The MSAP2000 AAMS leaves the factory with a default (in-band) management IP
address of 192.168.1.1 and a subnet mask of 255.255.255.0, (ff:ff:ff:00 in
hexadecimal notation), and the default gateway set at 192.168.1.254. Make sure
that you configure the IP parameters correctly before you connect an MSAP2000
AAMS to the network, otherwise, you may interrupt services already running.
28.3 IP Commands Summary
The following table lists the ip commands you can use with the MSAP2000
AAMS.
Table 62 IP Commands
COMMAND DESCRIPTION
ip
show Displays the management IP
address settings.
arp
show Displays the device’s IP Address
Resolution Protocol status.
flush Clears the device’s IP Address
Resolution Protocol status.
set <ip>[/
netmask]
gateway <gateway ip> Sets the IP address of the
device’s default gateway.
route
show Displays the routing table.
set <dst ip>[/
netmask]
<gateway ip>
[metric] <name>