Operation Manual

Chapter 17 Bandwidth MGMT
NBG-418N v2 User’s Guide
135
The following table describes the labels in this screen.
17.5 Advanced Screen
Use this screen to set up the QoS rules for the NBG-418N v2. Click Management > Bandwidth
MGMT > Advanced. The following screen displays.
Figure 100 Management > Bandwidth MGMT > Advanced
The following table describes the labels in this screen.
Table 58 Management > Bandwidth MGMT > Bandwidth MGMT
LABEL DESCRIPTION
Service Management
Enable Bandwidth
Management
Click the Enable Bandwidth Management check box to activate the bandwidth
management feature in the NBG-418N v2.
Apply Click Apply to save your changes in t his screen.
Reset Click Reset to begin configuring this screen afresh.
Table 59 Management > Bandwidth MGMT > Advanced
LABEL DESCRIPTION
QoS Setup
Total Bandwidth (0,
Unlimited)
This field shows the maximum number of data in kbps the NBG-418N v2 is allowed to
send out and allowed to come in through a source interface.
Up Stream Type the Up Stream or maximum outgoing transmission data rate (kbps) that is
allowed to go through the source interface on the NBG-418N v2.
Down Stream Type the Down Stream or maximum incoming transmission data rate (kbps) that is
allowed to go through the source interface on the NBG-418N v2.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
QoS Rules
# This field shows the index number of the QoS rule.
Source IP Address This field shows the source IP Address of the data traffic.
Max Bandwidth(kpbs)
Up Ceiling This field shows the maximum outgoing transmission data rate (kbps) that is allo wed to
go through the source interface on the NBG-418N v2.