Operation Manual

Chapter 4 Modes

NBG-418N v2 User’s Guide

4.3 Setting your NBG-418N v2 to AP Mode

1 Connect your computer to the LAN port of the NBG-418N v2.

2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode and 192.168.1.2 by

default in non-router mode.

3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and

type the IP address of the NBG-418N v2 as the web address in your web browser.

4 Log into the Web Configurator. See the Chapter 2 on page 16 for instructions on how to do this.

5 Go to Maintenance > Sys OP Mode > General and select Access Point.

6 A pop-up window appears providing information on this mode. Click OK in the pop-up message

window. Click Apply. Your NBG-418N v2 is now in AP Mode.

Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.

4.3.1 Status Screen (AP Mode)

Click on Status. The screen below shows the status screen in AP Mode.