Operation Manual

Chapter 4 Modes

NBG-418N v2 User’s Guide

The following table describes the sub-menus.

4.5 Setting your NBG-418N v2 to Client Bridge Mode

1 Connect your computer to the LAN port of the NBG-418N v2.

2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode and 192.168.1.2 by

default in non-router mode.

3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and

type the IP address of the NBG-418N v2 as the web address in your web browser.

4 Log into the Web Configurator. See the Chapter 2 on page 16 for instructions on how to do this.

5 Go to Maintenance > Sys OP Mode > General and select Client Bridge.

Table 15 Menu: Universal Repeater Mode

LINK TAB FUNCTION

Status This screen shows the NBG-418N v2’s general device, system and

interface status information. Use this screen to access the wizard, and

summary statistics tables.

Network

WLAN AP Select Use this screen to choose an access point that you want the NBG-418N v2

to connect to. You should know the security settings of the target AP.

General Use this screen to configure wireless LAN.

MAC Filter Use the MAC filter screen to configure the NBG-418N v2 to block access

to devices or block the devices from accessing the NBG-418N v2.

Advanced This screen allows you to configure advanced wireless settings.

WPS Use this screen to configure WPS.

WPS Station Use this screen to add a wireless station using WPS.

Scheduling Use this screen to schedule the times the Wireless LAN is enabled.

MBSSID Use this screen to configure multiple SSIDs on the NBG-418N v2.

LAN IP Use this screen to configure LAN IP address and subnet mask.

Maintenance

System General Use this screen to view and change administrative settings such as

system and domain names, password and inactivity timer.

Time Setting Use this screen to change your NBG-418N v2’s time and date.

Logs View Log Use this screen to view the logs for the categories that you selected.

Tools Firmware Use this screen to upload firmware to your NBG-418N v2.

Configuration Use this screen to backup and restore the configuration or reset the

factory defaults to your NBG-418N v2.

Restart This screen allows you to reboot the NBG-418N v2 without turning the

power off.

Sys OP Mode General This screen allows you to select the device operating mode: Router,

Access Point, Universal Repeater or Client Bridge.

Language Language This screen allows you to select the language you prefer.