Operation Manual

Chapter 4 Modes
NBG-418N v2 User’s Guide
43
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your NBG-418N v2 is now in Client Bridge mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.5.1 Status Screen (Client Bridge Mode)
Click on Status. The screen below shows the status screen in Client Bridge mode.
Figure 29 Status Screen (Client Bridge Mode)
The following table describes the labels shown in the Status screen.
Table 16 Status Screen (Client Bridge Mode)
LABEL DESCRIPTION
Device Information
System Name This is the System Name you enter in the Maintenance > System >
General screen. It is for identification purposes.