Operation Manual

Chapter 5 Tutorials
NBG-418N v2 User’s Guide
58
2 Go to Management > Bandwidth MGMT > Advanced and enter 819200 in the Total Up
Stream and Down Stream Bandwidth fields in the QoS Setup section. It is recommended to set
this number to match the actual upstream data rate.
Click Apply or Reset to clear the fields.
3 Then, Click Add in the QoS Rules section and several box fields appears. Enter 192.168.1.10 in
the Source IP field, 192.168.1.10/32 will appear in the field, the 32-bits network is IPv4
addresses block that is assigned by your ISP. Next, enter 150000 for Up Celing field and 600000
for Down Ceiling field and click Add. Note that the Up/Down Ceiling numbers should not exceed
the Total Bandwidth. You have successfully set a specific minimum and maximum bandwidth for
this particular IP address.
4 If you wish to delete a QoS Rules entry, click the Delete check box of the rule and click Delete
button. To clear the Source IP, Up/Down Ceiling box fields, click Reset button.