Operation Manual

Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
74
Figure 53 Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Table 29 Network > Wireless LAN > AP Select
LABEL DESCRIPTION
AP Select
First Click First button to go to the first page of the AP select table.
Previous Click Previous button to go to the Previous page in the AP select table.
Next Click Next button to go to the next page in the AP select table.
Last Click Last button to go to the last page of the AP select table.
Select Use the radio button to select the wireless device to which you want to connect.
SSID This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
Mode This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
Security Mode This displays the type of security configured on the wireless device. OPEN means no
security is configured and you can connect to it without a password.
Strength This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your NBG-418N v2 and this device.
Refresh Click this button to search for available wireless devices within transmission range and
update this table.
Connect Click this button to associate to the selected wireless device.