Operation Manual

Chapter 7 WAN
NBG-418N v2 User’s Guide
90
Connection Type Select Continuous if you do not want the connection to time out.
Select Connection on Demand if you want to connect for a certain amount of time
before the router automatically disconnects from the PPPoE server. If you select this you
will need to enter the number of minutes in the Idle timeout field.
Select Manual if want to make the connection manually.
Connect/
Disconnect
Click Connect to establish PPPoE connection to the IPv6 Internet or click Disconnect to
stop the connection.
IPv6 DNS Settings
Obtain DNS Server
address
automatically
Click the Obtain DNS server address automatically radio button to get a DNS server
address from your ISP’s server.
Use the following
DNS address
Click Use the following DNS address radio button to use a fixed DNS address.
Primary/Secondary
DNS Address
Enter the first/second IPv6 DNS server address assigned by the ISP.
Lan IPv6 Address Settings
Enable DHCP-PD Click Enable DHCP-PD (DHCP-Prefix delegation) to allow NBG-418N v2 assign prefixes
to DHCP clients.
LAN IPv6 Address Enter the IPv6 address for the LAN interface in this field.
LAN IPv6 Link-Local
Address
This shows the IPv6 Link-local address in the LAN side. This is used by NBG-418N v2
when communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable
Autoconfiguration
Click Enable Autoconfiguration if you want the devices on your local area network to
obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration
Type
Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
If you select SLAAC + Stateless DHCPv6, type in the Router Advertisement
Lifetime which is amount of time in minutes that a device may have an IPv6 address
before it is required to renew the lease.
IPv6 Address
Range(Start)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address
Range(End)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the largest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address
Lifetime
If you select Stateful (DHCPv6), specify how long (in minutes) the IPv6 addresses
remain valid.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 39 Network > WAN > IPv6 (continued)(PPPoE)
LABEL DESCRIPTION