Operation Manual

Chapter 26 Bandwidth Management
NBG4615 User’s Guide
202
Figure 128 Bandwidth Management Rule Configuration: User-defined Service
The following table describes the labels in this screen.
See Appendix E on page 295 for commonly used services and port numbers.
Table 82 Bandwidth Management Rule Configuration: User-defined Service
LABEL DESCRIPTION
BW Budget Select Maximum Bandwidth or Minimum Bandwidth and specify the
maximum or minimum bandwidth allowed for the rule in kilobits per
second.
Destination Address
Start
Enter the starting IP address of the destination computer.
The NBG4615 applies bandwidth management to the service or
application that is entering this computer.
Destination Address End Enter the ending IP address of the destination computer.
The NBG4615 applies bandwidth management to the service or
application that is entering this computer.
Destination Port This is the port number of the destination that define the traffic type, for
example TCP port 80 defines web traffic.
Source Address Start Enter the starting IP address of the computer that initializes traffic for the
application or service.
The NBG4615 applies bandwidth management to traffic initiating from this
computer.
Source Address End Enter the ending IP address of the computer that initializes traffic for the
application or service.
The NBG4615 applies bandwidth management to traffic initiating from this
computer.
Source Port This is the port number of the source that define the traffic type, for
example TCP port 80 defines web traffic.
Protocol Select the protocol (TCP, UDP, BOTH) for which the bandwidth
management rule applies.
If you select BOTH, enter the protocol for which the bandwidth
management rule applies. For example, ICMP for ping traffic.
Apply Click Apply to save your customized settings.
Cancel Click Cancel to exit this screen without saving.