Operation Manual

Chapter 12 WISP Mode

NBG4615 User’s Guide

2 The default IP address of the NBG4615 is “192.168.1.1”. If you did not change this, you can use the

same IP address in WISP Mode. Open a web browser such as Internet Explorer and type

“192.168.1.1” as the web address in your web browser.

If you changed the IP address of your NBG4615 while in Router mode, use this IP address in WISP

Mode. The WISP Mode IP address is always the same as the Router mode IP address.

Note: After clicking Login, the Easy Mode appears. Refer to Section on page 53 for the

Easy Mode screens. Click Expert mode to see the screens described in the

sections following this.

12.4 WISP Mode Status Screen

Click to open the status screen.

Figure 64 Status: WISP Mode

The following table describes the labels shown in the Status screen.

Table 38 Status Screen: WISP Mode

LABEL DESCRIPTION

Logout Click this at any time to exit the Web Configurator.

Device Information

Host Name This is the System Name you enter in the Maintenance > General screen. It is for

identification purposes.

Firmware Version This is the firmware version and the date created.