Operation Manual

Chapter 12 IPv6

NBG6515 User’s Guide

100

Type Select SLAAC + RDNSS to enable IPv6 stateless auto-configuration on this interface. The

interface will generate an IPv6 IP address itself from a prefix obtained from an IPv6 router

in the network.

Select SLAAC + Stateless DHCPv6 to enable IPv6 stateless auto-configuration on this

interface. The interface will get an IPv6 address from an IPv6 router and the DHCP server.

The IP address information gets through DHCPv6.

Select Stateful to allow a DHCP server to assign and pass IPv6 network addresses, prefixes

and other configuration information to DHCP clients.

Router

Lifetime

Specify how long (in minutes) the IPv6 addresses remain valid.

Address (start) If you select Stateful in the Type field, specify the range of IPv6 addresses from which the

DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the IPv6

addresses which are to be allocated.

Address (end) If you select Stateful in the Type field, specify the range of IPv6 addresses from which the

DHCPv6 server assigns to the clients. Enter the largest value of the last block of the IPv6

addresses which are to be allocated.

Apply Click Apply to save your changes back to the NBG.

Reset Click Reset to begin configuring this screen afresh.

Table 50 Network > IPv6 > General (continued)

LABEL DESCRIPTION