Operation Manual

Chapter 6 Easy Mode
NBG6515 User’s Guide
41
Note: Don’t worry if the Network Map does not display in your web browser. This feature
may not be supported by your system. You can still configure the Control Panel
(Section 6.6 on page 41) in the Easy Mode and the NBG features that you want to
use in the Expert Mode.
When you log into the Network Configurator, the Network Map is shown as follows.
Figure 29 Network Map
The line connecting the NBG to the gateway becomes green when the NBG is able to ping the
gateway. It becomes red when the ping initiating from the NBG does not get a response from the
gateway. The same rule applies to the line connecting the gateway to the Internet.
You can also view the devices (represented by icons indicating the kind of network device)
connected to the NBG, including those connecting wirelessly. Right-click on the NBG icon to refresh
the network map and go to the Wizard. Right click on the other icons to view information about the
device.
6.6 Control Panel
The features configurable in Easy Mode are shown in the Control Panel.
Figure 30 Control Panel
Switch ON to enable the feature. Otherwise, switch OFF. If the feature is turned on, the green light
flashes. If it is turned off, the red light flashes.
Additionally, click the feature to open a screen where you can edit its settings.