Operation Manual

Chapter 10 Tutorials
NBG6515 User’s Guide
76
Follow the steps below to configure the wireless settings on your NBG.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 3.2 on page 26).
1 Open the Wireless LAN 2.4G/5G > General screen in the AP’s Web Configurator.
2 Enable Wireless LAN.
3 Enter SSID_Example3 as the SSID and select a channel. Set security mode to WPA-PSK and
enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click Apply.
Figure 58 Tutorial: Network > Wireless LAN 2.4G/5G > General
4 Open the Status screen. Verify your wireless and wireless security settings under Device
Information and check if the WLAN connection is up under Interface Status.
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)