Operation Manual

Chapter 11 Wireless LAN
NBG6515 User’s Guide
88
Refer to Table 38 on page 84 for descriptions of the other labels in this screen.
11.5.3 WPA-PSK/WPA2-PSK
Click Network > Wireless LAN 2.4G or Wireless LAN 5G to display the General screen. Select
WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 68 Network > Wireless LAN 2.4G/5G> General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the NBG and the wireless stations must use
the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one time.
Apply Click Apply to save your changes back to the NBG.
Reset Click Reset to begin configuring this screen afresh.
Table 40 Network > Wireless LAN 2.4G/5G > General: Static WEP (continued)
LABEL DESCRIPTION
Table 41 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA
Compatible
This field appears when you choose WPA-PSK2 as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to your
NBG.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.