User's Manual

Chapter 1 Introduction

ARMOR Z1 User’s Guide

Figure 2 Rear Panel

Internet White On The ARMOR Z1 has an IP connection but no traffic.

Your device has a WAN IP address (either static or assigned by a

DHCP server), PPP negotiation was successfully completed (if

used) and the connection is up.

Blinking The ARMOR Z1 is sending or receiving IP traffic.

Off The ARMOR Z1 does not have an IP connection.

2.4G WLAN/WPS White On The ARMOR Z1 is ready and the 2.4GHz wireless LAN is on, but

is not sending/receiving data through the wireless LAN.

Blinking The ARMOR Z1 is sending/receiving data through the wireless

LAN.

Off The wireless LAN is not ready or has failed.

Amber On WPS is enabled. The ARMOR Z1 is in the process of firmware

upgrading, configuration restoring, or resetting.

Blinking The ARMOR Z1 is negotiating a WPS connection with a wireless

client.

Off WPS is disabled.

5G WLAN/WPS White On The ARMOR Z1 is ready and the 5GHz wireless LAN is on, but is

not sending/receiving data through the wireless LAN.