User's Manual

Chapter 15 Maintenance
ARMOR Z1 User’s Guide
146
The following table describes the labels in this screen.
15.11 Log Screen
The Web Configurator allows you to look at all of the ARMOR Z1’s logs in one location.
You can configure which logs to display in the Log screen. Select the logs you wish to display. Click
Apply to save your settings. Click Cancel to start the screen afresh.
Use this screen to see the logged messages for the ARMOR Z1. The log wraps around and deletes
the old entries after it fills. Select what logs you want to see from the Display drop list. The log
choices depend on your settings above this screen. Click Refresh to renew the log screen. Click
Clear Log to delete all the logs.
Table 59 Expert > Maintenance > Remote Management > Wake On LAN
LABEL DESCRIPTION
Wake On LAN over WAN Settings
Enable Wake On
LAN over WAN
Select Enable to have the ARMOR Z1 forward a WoL “Magic Packet” to all devices on the
LAN if the packet comes from the WAN or remote network and uses the port number
specified in the Port field. A LAN device whose hardware supports Wake on LAN then will
be powered on if it is turned off previously.
Port Type a port number from which a WoL packet is forwarded to the LAN.
Wake On LAN
Wake MAC
Address
Enter the MAC Address of the device on the network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Start Click this to have the ARMOR Z1 generate a WoL packet and forward it to turn the specified
device on.
A screen pops up displaying MAC address error if you input the MAC address incorrectly.
Apply Click Apply to save your changes back to the ARMOR Z1.
Cancel Click Cancel to begin configuring this screen afresh.