User's Manual

ARMOR Z1 User’s Guide
150
CHAPTER 16
Troubleshooting
16.1 Overview
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• ARMOR Z1 Access and Login
• Internet Access
• Resetting the ARMOR Z1 to Its Factory Defaults
• Wireless Connections
• USB Device Problems
16.2 Power, Hardware Connections, and LEDs
The ARMOR Z1 does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the ARMOR Z1.
2 Make sure the power adaptor or cord is connected to the ARMOR Z1 and plugged in to an
appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the ARMOR Z1.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.7 on page 12.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the ARMOR Z1.