User's Manual

Chapter 16 Troubleshooting
ARMOR Z1 User’s Guide
151
5 If the problem continues, contact the vendor.
16.3 ARMOR Z1 Access and Login
I don’t know the IP address of my ARMOR Z1.
6 The default IP address of the ARMOR Z1 in Router Mode is 192.168.1.1. If the ARMOR Z1 obtains
a WAN IP address in the same subnet as the LAN IP address 192.168.1.1, the default LAN IP
address will be changed to 10.0.0.1 automatically. See Auto-IP Change on page 67 for more
information.
The default IP address of the ARMOR Z1 in Access Point Mode is 192.168.1.2.
7 If you changed the IP address and have forgotten it, you might get the IP address of the ARMOR Z1
in Router Mode by looking up the IP address of the default gateway for your computer. To do this
in most Windows computers, click Start > Run, enter cmd, and then enter ipconfig. The IP
address of the Default Gateway might be the IP address of the ARMOR Z1 (it depends on the
network), so enter this IP address in your Internet browser.
8 If your ARMOR Z1 in Access Point Mode is a DHCP client, you can find your IP address from the
DHCP server. This information is only available from the DHCP server which allocates IP addresses
on your network. Find this information directly from the DHCP server or contact your system
administrator for more information.
9 Reset your ARMOR Z1 to change all settings back to their default. This means your current settings
are lost. See Section 16.5 on page 154 in the Troubleshooting for information on resetting your
ARMOR Z1.
I forgot the password.
1 The default password is 1234.
2 If this does not work, you have to reset the device to its factory defaults. See Section 16.5 on page
154.
I cannot see or access the Login screen in the Web Configurator.
1 Make sure you are using the correct IP address.