User's Manual

Chapter 6 Router Mode
ARMOR Z1 User’s Guide
36
Figure 25 Expert Mode: Status > System Status: Router Mode
The following table describes the labels shown in the Status screen.
Table 15 Expert Mode: Status > System Status: Router Mode
LABEL DESCRIPTION
Device Information
Item This column shows the type of data the ARMOR Z1 is recording.
Data This column shows the actual data recorded by the ARMOR Z1.
Host Name This is the System Name you enter in the Maintenance > General screen. It is for
identification purposes.
Model Number This is the model name of your device.
Firmware Version This is the firmware version.
Sys OP Mode This is the device mode (Section 4.1.2 on page 26) to which the ARMOR Z1 is set - Router
Mode.
WAN Information
MAC Address This shows the WAN Ethernet adapter MAC Address of your device.
IP Address This shows the WAN port’s IP address.
IP Subnet Mask This shows the WAN port’s subnet mask.
Default Gateway This shows the WAN port’s gateway IP address.
IPv6 Address This shows the IPv6 address of the ARMOR Z1 on the WAN.