User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6818 User’s Guide
109
for example, 00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure this
screen.
Use this screen to change your NBG6818’s MAC filter settings. Click Settings > WiFi > MAC Filter to show
following screen.
Figure 60 Settings > WiFi > MAC Filter
The following table describes the labels in this screen.
10.4.1 Add MAC Address Screen
Use this screen to configure the MAC address you want to add to the MAC address list. Click Settings >
WiFi > MAC Filter > Add to show the following screen.
Table 34 Settings > WiFi > MAC Filter
LABEL DESCRIPTION
MAC Filter Select to turn on (Enable) or off (Disable) MAC address filtering.
Filter Action Define the filter action for the list of MAC addresses in the MAC Filter Summary table.
Select Allow to permit access to the NBG6818. MAC addresses not listed will be denied access to
the NBG6818.
Select Deny to block access to the NBG6818. MAC addresses not listed will be allowed to access
the NBG6818.
MAC Address List (Max Limit : 64)
This field displays the MAC address of the wireless station you want to filter.
Click to configure the MAC address.
Click to delete the MAC address.
Add Click to add a rule in the MAC Address List.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to reload the previous configuration for this screen.