User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6818 User’s Guide
111
Figure 62 Settings > WiFi > WPS
The following table describes the labels in this screen.
Table 36 Settings > WiFi > WPS
LABEL DESCRIPTION
WPS
WiFi WPS Status Select Enable to turn on the WPS feature. Otherwise, select Disable.
Push Button Use this button when you use the PBC (Push Button Configuration) method.
Click this to start WPS-aware wireless station scanning and wireless security information
synchronization.
WPS Status
Status This displays Configured when a wireless station has connected to the NBG6818 using WPS
and wireless setup or security settings have been changed from default. The current wireless
setup and security settings also appear in this screen.
This displays Unconfigured if WPS is disabled and there are no wireless setup or security
changes on the NBG6818 or if you click Release Configuration to restore wireless setup and
security settings to default.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the
NBG6818.
SSID This is the name of the wireless network (the NBG6818’s first SSID) that WPS clients connect to.
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to reload the previous configuration for this screen.