User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 11 LAN
NBG6818 User’s Guide
121
Figure 71 Settings > LAN > IPv6 LAN
The following table describes the labels in this screen.
Table 41 Settings > Expert Mode > LAN > IPv6 LAN
LABEL DESCRIPTION
LAN IPv6 Address Assignment
Enable_DHCPv6-PD
Select this option to use DHCPv6 prefix delegation. The NBG6818 will obtain an IPv6 prefix from the ISP or a
connected uplink router for the LAN.
Autoconfiguration
Type
Select SLAAC + RDNSS to enable IPv6 stateless auto-configuration on this interface. The
interface will generate an IPv6 IP address itself from a prefix obtained from an IPv6 router in
the network.
Select SLAAC + Stateless DHCPv6 to enable IPv6 stateless auto-configuration on this
interface. The interface will get an IPv6 address from an IPv6 router and the DHCP server. The
IP address information gets through DHCPv6.
Select Stateful DHCPv6 to allow a DHCP server to assign and pass IPv6 network addresses,
prefixes and other configuration information to DHCP clients.
IPv6 Address range
(Start)
Enter the beginning of the range of IP addresses that this address object represents.