User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 13 System
NBG6818 User’s Guide
139
Figure 86 Settings > System > Operation Mode
The following table describes the labels in this screen.
Note: If you select the incorrect system operation Mode you may not be able to connect to
the Internet
13.8 Logs Screen
Use this screen to see the logged messages for the NBG6818.
You can configure which logs to display in the Log screen.
The newest log replaces the oldest log after it fills. Select what logs you want to see from the Log Type
drop-down list box. The log choices depend on your other settings in the System screens. Click Refresh to
renew the log screen. Click Export to save the current list of logs to your computer. Click Clear to delete
all the logs.
Table 49 Settings > System > Operation Mode
LABEL DESCRIPTION
Standard Mode Select Standard Mode if your device routes traffic between a local network and
another network such as the Internet. This mode offers services such as a firewall or
bandwidth management.
You can configure the IP address settings on your WAN port. Contact your ISP or
system administrator for more information on appropriate settings.
Bridge Mode Select Bridge Mode if your device bridges traffic between clients on the same
network.
• In Bridg3e Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled
WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• Router functions (such as NAT, bandwidth management, remote management,
firewall and so on) are not available when the NBG6818 is in Bridge Mode.
• The IP address of the device on the local network is set to 192.168.123.2.
Apply Click Apply to save your settings.
Cancel Click Cancel to return your settings to the default (Standard).