User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 6 Bridge Mode
NBG6818 User’s Guide
39
CHAPTER 6
Bridge Mode
6.1 Overview
Use your NBG6818 as a bridge if you already have a router or gateway on your network. In this mode
your NBG6818 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. See the
figure below for an example.
Figure 16 NBG6818 in Bridge Mode
Many screens that are available in Standard Mode are not available in Bridge Mode, such as port
forwarding and firewall. See Section 3.3 on page 29 for more information.
6.2 What You Can Do
• Set up a network with the NBG6818 as a bridge (Section 6.3 on page 39).
• Use the Status screen to view read-only information about your NBG6818 (Section 6.4 on page 41).
6.3 Setting your NBG6818 to Bridge Mode
1 Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how
to do this.