User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
NBG6818 User’s Guide
42
CHAPTER 7
Tutorials
7.1 Overview
This chapter provides tutorials for setting up your NBG6818.
• Run a Speed Test
• Configure the NBG6818’s WiFi Networks
• Enable or Disable a WiFi Network
• Add Clients to a Profile
• Set a Profile’s WiFi Schedule
• Pause or Resume Internet Access on a Profile
• Change Your NBG6818 Operating Mode
• Configure a Port Forwarding Rule
7.2 Run a Speed Test
With the NBG6818 Web Configurator, you can check the speed of the connection between your
NBG6818 and the broadband modem/router.
1 Click the Navigation Panel icon on the top-left corner ( ), and click Diagnose to open the Advanced
Speed Test screen. Use this screen to view all the available connections in your NBG6818 System.
2 Click TEST to perform a speed test. This shows data rates for both upstream and downstream traffic. Click
TEST AGAIN to update the information in this screen.