User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 9 WAN
NBG6818 User’s Guide
79
Auto-IP Change
When the NBG6818 gets a WAN IP address or a DNS server IP address which is in the same subnet as the
LAN IP address 192.168.123.1, Auto-IP-Change allows the NBG6818 to change its LAN IP address to
10.0.0.1 automatically. If the NBG6818’s original LAN IP address is 10.0.0.1 and the WAN IP address is in
the same subnet, such as 10.0.0.3, the NBG6818 switches to use 192.168.123.1 as its LAN IP address.
Figure 41 Auto-IP-Change Example
Auto-IP-Change only works under the following conditions:
• The NBG6818 must be in Standard Mode (see Section 13.7 on page 137 for more information) for Auto-
IP-Change to become active.
• The NBG6818 is set to receive a dynamic WAN IP address.
9.4 Internet Connection Screen
Use this screen to change your NBG6818’s Internet access settings. The screen varies depending on the
encapsulation method you select. Click Settings > Internet > Internet Connection.
9.4.1 IPoE Encapsulation
This screen displays when you select IPoE encapsulation.