Users Manual Part 1

Chapter 9 Wireless
NBG7510 User’s Guide
106
9.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any data
encryption or authentication.
Note: If you do not enable any
WiFi
security on your Zyxel Device, your network is accessible to
any wireless networking device that is within range.
Bandwidth Select whether the Zyxel Device uses a wireless channel width of 20MHz, 40mHz, 20/40MHz, 20/
40/80MHz or 20/40/80/160MHz.
A standard 20 MHz channel offers transfer speeds of up to 150 Mbps whereas a 40 MHz channel
uses two standard channels and offers speeds of up to 300 Mbps.
40 MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. The wireless clients must also support 40 MHz. It is often better to use the 20 MHz
setting in a location where the environment hinders the wireless signal.
An 80 MHz channel groupsadjacent 40 MHz channels into pairs to increase bandwidth even
higher.
Select 20MHz if you want to lessen radio interference with other wireless devices in your
neighborhood or the wireless clients do not support channel bonding.
Because not all devices support 40 MHz and/or 160 MHz channels, select 20/40MHz or 20/40/80/
160MHz to allow the Zyxel Device to adjust the channel bandwidth automatically.
Control
Sideband
This is available for some regions when you select a specific channel and set the Bandwidth field
to 40MHz or 20/40MHz. Set whether the control channel (set in the Channel field) should be in
the Lower or Upper range of channel bands.
Wireless/WiFi Network Settings
Wireless/WiFi
Network Name
The SSID (Service Set IDentity) identifies the service set with which a wireless device is associated.
Wireless devices associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for WiFi.
Max Clients Specify the maximum number of clients that can connect to this network at the same time.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
This check box is grayed out if the WPS function is enabled in the Network Setting > Wireless >
WPS screen.
Multicast
Forwarding
Select this check box to allow the Zyxel Device to convert wireless multicast traffic into wireless
unicast traffic.
BSSID This shows the MAC address of the wireless interface on the Zyxel Device when WiFi is enabled.
Security Level
Security Mode Select More Secure (Recommended) to add security on this wireless network. The wireless clients
which want to associate to this network must have same wireless security settings as the Zyxel
Device. When you select to use a security, additional options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 30 Network Setting > Wireless > General (continued)
LABEL DESCRIPTION