Users Manual Part 1

Chapter 6 Rover App Tutorials

NBG7510 User’s Guide

4 Change the default SSID and WiFi key on the Rover Router for better WiFi security; see Section 6.7.1 on

page 66 for more information. After applying changes, you will need to reconnect to Rover Router

again using the new SSID and WiFi key.

5 Use WPS to copy the SSID and WiFi key from the Rover Router to the Rover AP. Press the WPS button on

the Rover Router for 1.5 to 4 seconds and then press the WPS button on the Rover AP until the LED blinks

in purple within 120 seconds.

6 Use the Rover app and the table below to see if the access point is securely connected to the router;

see Section 6.8 on page 71 for more information.

6.4.2 Connect the Rover Router to the WRE6605 AP Using a Wired

Connection

Follow the steps below to set up the Rover Router with an access point (the WRE6605AP as an example).

Connect the Rover Router to the Internet. The Rover Router must be connected to a modem/router

using an Ethernet cable. Then, connect the LAN port on the WRE6605AP to a LAN port on the Rover

Router using another Ethernet cable.

Table 12 Link Quality

ICON CONNECTION TYPE WIFI STATUS

Wired Wired Connection

Wired Blocked

Wireless Good to Go

Wireless Too Close to the Router

Wireless Weak WiFi

Wireless Blocked

Table 13 Device Role

DEVICE TERM ROLE

Zyxel Device in Router mode Rover Router Router

WRE6605 in AP mode WRE6605 AP Access Point