Users Manual Part 1

Chapter 8 Broadband

NBG7510 User’s Guide

Bridge Mode

Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the

connection you want to configure. The following example screen displays when you select Bridge

mode.

Figure 53 Network Setting > Broadband > Add or Edit New WAN Interface (Ethernet-Bridge Mode)

The following table describes the fields in this screen.

Apply as Default

Gateway

Select this option to have the Zyxel Device use the WAN interface of this connection as the

system default gateway.

DS-Lite

This is available only when you select IPv6 Only in the IPv4/IPv6 Mode field. Enable Dual Stack

Lite to let local computers use IPv4 through an ISP’s IPv6 network. See Dual Stack Lite on page 93

for more information.

Click this switch to let local computers use IPv4 through an ISP’s IPv6 network. When the switch

goes to the right , the function is enabled. Otherwise, it is not.

DS-Lite Relay

Server IP

Specify the transition router’s IPv6 address.

Cancel Click Cancel to restore your previously saved settings.

Apply Click Apply to save your changes.

Table 28 Network Setting > Broadband > Add/Edit New WAN Interface (VDSL over PTM or Ethernet-

Bridge Mode)

LABEL DESCRIPTION

General Click this switch to enable or disable the interface. When the switch goes to the right , the

function is enabled. Otherwise, it is not.

Name Enter a service name of the connection.

Type

(Ethernet)

Select Ethernet as the interface that you want to configure. This field is read-only is you are editing

the WAN interface.

Mode Select Bridge when your ISP provides you more than one IP address and you want the connected

computers to get individual IP address from ISP’s DHCP server directly. If you select Bridge, you

cannot use routing functions, such as Firewall, DHCP server and NAT on traffic from the selected LAN

port(s).

VLAN Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right

, the function is enabled. Otherwise, it’s not.

Table 27 Network Setting > Broadband > Add or Edit New WAN Interface (Routing Mode) (continued)

LABEL DESCRIPTION