User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG7815 User’s Guide
113
10.4.1 Add MAC Address Screen
Use this screen to configure the MAC address you want to add to the MAC address list. Click Settings >
WiFi > MAC Filter > Add to show the following screen.
Figure 60 Settings > WiFi > MAC Filter > Add
The following table describes the labels in this screen.
10.5 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN and check the current WPS status.
Click Settings > WiFi > WPS to show the following screen.
Note: With WPS, wireless clients can only connect to the wireless network using the first SSID on
the NBG7815.
Table 35 Settings > WiFi > MAC Filter > Add
LABEL DESCRIPTION
Type This field displays the MAC address of the wireless station. If you select User-Defined,
enter the MAC address(es) manually.
MAC Address Enter a MAC address manually in this field if you select User-Defined in the Type field.
Apply Click Apply to save your changes back to the NBG7815.
Cancel Click Cancel to exist this screen without saving.