User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 11 LAN
NBG7815 User’s Guide
117
Figure 64 LAN and WAN IP Addresses
The LAN parameters of the NBG7815 are preset in the factory with the following values:
• IPv4 address of 192.168.123.1 with subnet mask of 255.255.255.0 (24 bits)
• DHCP server enabled with 128 client IPv4 addresses starting from 192.168.123.33.
These parameters should work for the majority of installations.
11.4 LAN IP Screen
Use this screen to change the IP address for your NBG7815 in Standard Mode. Click Settings > LAN > LAN
IP to show the following screen.