User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 13 System
NBG7815 User’s Guide
138
13.5 Remote Access Screen
Use this screen to change your NBG7815’s remote management settings. You can use HTTPS or Wake on
LAN to access and manage the NBG7815.
Wake On LAN (WoL) allows you to remotely turn on a device on the network, such as a computer,
storage device or media server. To use this feature, the remote hardware (such as the network adapter
on a computer) must support Wake On LAN using the “Magic Packet” method.
You need to know the MAC address of the remote client to use this feature. It may be on a label on the
device.
Click Settings > System > Remote Access to show the following screen.
Note: You can only enable Remote Assistant in this screen if you are using bridge mode.
Figure 80 Settings > System > Remote Access (Standard Mode)