User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 6 Bridge Mode
NBG7815 User’s Guide
40
CHAPTER 6
Bridge Mode
6.1 Overview
Use your NBG7815 as a bridge if you already have a router or gateway on your network. In this mode
your NBG7815 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. See the
figure below for an example.
Figure 16 NBG7815 in Bridge Mode
Many screens that are available in Standard Mode are not available in Bridge Mode, such as port
forwarding and firewall. See Section 3.3 on page 30 for more information.
6.2 What You Can Do
• Set up a network with the NBG7815 as a bridge (Section 6.3 on page 40).
• Use the Status screen to view read-only information about your NBG7815 (Section 6.4 on page 42).
6.3 Setting your NBG7815 to Bridge Mode
1 Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how
to do this.