User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 6 Bridge Mode
NBG7815 User’s Guide
42
6.4 Bridge Mode Status Screen
Click Settings > System > Status to open the status screen.
Figure 19 Settings > System > Status (Bridge Mode)
The following table describes the labels shown in the Status screen.
Table 6 Settings > System > Status (Bridge Mode)
LABEL DESCRIPTION
System
Model Name This is the model name of your device.
Firmware Version This is the firmware version.
System Operation Mode This is the device mode to which the NBG7815 is set, see Section 13.7 on page 140
for more information.
Enable IPv4 Firewall This shows if the IPv4 firewall is enabled on the NBG7815.
Enable IPv6 Simple Security This shows if the IPv6 firewall is enabled on the NBG7815.
System Uptime This is the total time the NBG7815 has been on.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
DHCP Server This shows the LAN port’s DHCP role - Enable or Disable.
IPv6 Address This shows the current IPv6 address of the NBG7815 in the LAN.