User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 7 Tutorials
NBG7815 User’s Guide
48
7.5 Add Clients to a Profile
Profiling clients allows you to easily block/allow Internet access or set a schedule for all client devices in
the same profile.
Note: This is not available if you are using bridge mode.
1 Click the Navigation Panel icon on the top-left corner ( ), and click Parental Control to open the
Device screen. Use the Device screen to view all the clients in your NBG7815.
2 Click the icon under Action ( ) to view the user information. In Device Detail, select a predefined profile
and click Apply.