User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG7815 User’s Guide
59
Figure 20 Parental Control > Device
The following table describes the fields in this screen.
8.2.1.1 Edit Device Detail Screen
Use this screen to configure basic settings for the device. Click the Action icon (), and then the Edit
icon ( ) to show the following screen.
Table 8 Parental Control
LABEL DESCRIPTION
Sort By Choose to sort the order of your devices by Type or Name.
Connect to Choose whether you want to show devices that are connected to Main Network or
devices that are connected Guest Network.
Choose All if you want to show all devices.
No. This shows the index number of the rule.
Type The shows the type of device to which this rule applies.
Network This shows the type of network the devices are connected to.
Name This shows the name of the user to which this rule applies.
MAC This field shows the MAC address of the device with the name in the Name field.
Every Ethernet device has a unique MAC (Media Access Control) address which
uniquely identifies a device. The MAC address is assigned at the factory and consists
of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02.
IP Address This field displays the IP address relative to the No. field listed above.
Profile This shows the name of the rule that is applied to the device.
If no rule exists, unassigned is showed in this field.
Action Click the Action icon ( ) to configure a rule for the device.