User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG7815 User’s Guide
64
8.3.2 OpenVPN Account Screen
Use the OpenVPN Account List screen to view the basic information of the NBG7815 OpenVPN server.
Use the OpenVPN Account Status screen to view the basic information of clients that are connected to
the NBG7815 OpenVPN server
Note: At the time of writing, up to 16 OpenVPN clients can connect to the NBG7815
OpenVPN server at the same time.
Figure 26 OpenVPN Account
Server Port The default server port number is 1194. You can change it if needed. However,
clients connected to this OpenVPN Server account will have to use the same port
number in order to access the server account.
VPN Subnet/ Netmask The fields define the network form which OpenVPN clients can connect to the
NBG7815 OpenVPN server.
Enter an IPv4 address and subnet mask.
Advertise DNS to Clients Select Enable if you want the NBG7815 to broadcast its OpenVPN server to
OpenVPN clients in its VPN network defined previously.
Key Setting Click the Change Key button if you want to change the key your clients use to
access to your OpenVPN Server account.
You do not need to click Change Key the first time to configure this screen.
Periodically changing the key is recommended, but you must export the new .opvn
configuration file and send it to all OpenVPN clients so that they can they use the
new key.
Export Config Click Export Config to export your configuration to an .ovpn file that OpenVPN
clients need to connect to the NBG7815 OpenVPN server.
Apply Click Apply to save your changes back to the NBG7815.
Cancel Click Cancel to begin configuring this screen afresh.
Table 12 OpenVPN Server
LABEL DESCRIPTION