User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 9 WAN
NBG7815 User’s Guide
80
Auto-IP Change
When the NBG7815 gets a WAN IP address or a DNS server IP address which is in the same subnet as the
LAN IP address 192.168.123.1, Auto-IP-Change allows the NBG7815 to change its LAN IP address to
10.0.0.1 automatically. If the NBG7815’s original LAN IP address is 10.0.0.1 and the WAN IP address is in
the same subnet, such as 10.0.0.3, the NBG7815 switches to use 192.168.123.1 as its LAN IP address.
Figure 41 Auto-IP-Change Example
Auto-IP-Change only works under the following conditions:
• The NBG7815 must be in Standard Mode (see Section 13.7 on page 140 for more information) for Auto-
IP-Change to become active.
• The NBG7815 is set to receive a dynamic WAN IP address.
9.4 Internet Connection Screen
Use this screen to change your NBG7815’s Internet access settings. The screen varies depending on the
encapsulation method you select. Click Settings > Internet > Internet Connection.
9.4.1 IPoE Encapsulation
This screen displays when you select IPoE encapsulation.