User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 9 WAN
NBG7815 User’s Guide
81
Figure 42 Settings > Internet > Internet Connection: IPoE (IPv4 Only)
The following table describes the labels in this screen.
Table 22 Network > WAN > Internet Connection: IPoE Encapsulation
LABEL DESCRIPTION
Internet Connection
Internet Service
Provider Type
You must choose the IPoE option when the WAN port is used as a regular Ethernet.
IPv4 / IPv6 Select IPv4 Only if you want the NBG7815 to run IPv4 only.
Select Dual Stack to allow the NBG7815 to run IPv4 and IPv6 at the same time.
IPv4 Address
Automatic IP (DHCP) Select this option If your ISP did not assign you a fixed IP address. This is the default selection.